Mobile Crossing BLUETOOTH GPS Betriebsanweisung PDF herunterladen (Seite 8)

Using the GPS for the first time

Using the GPS for the first timeUsing the GPS for the first time

by the driver when it was installed. The Baud rate will need to be set

to 4800. The CDROM contains the GPS Information command

which can be used for test purposes.

This unit has a built-in battery for power. The battery will last about 8

hours on a full charge. External power is recommended for

extended or unlimited use in a vehicle. A vehicle power converter /

recharger is included.

Using the GPS for the first time

The very first time a GPS is used in a totally new area it will take a

little longer than usual to get a location fix. Any GPS aware

application can be used to perform this initialization but it is best if

the application has some sort of GPS status display. Pocket PC

users will find the included GPSInfo command perfect for this task.

The following steps can be used:

1. Be sure the GPS battery is fully charged.

2. Take the GPS unit and the computer outside and select a

location with a good sky view.

3. Be sure that Bluetooth communication is enabled. The

Bluetooth lamp on the GPS (Blue on the left as shown

below) blinks slowly when searching for a connection and

blinks quicker once a connection is established. The

effective range of the Bluetooth connection is up to 32 feet

but don’t be surprised if it is less.

4. Run the application and select the GPS receiver.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Keine Kommentare

Mobile Crossing BLUETOOTH GPS Betriebsanweisung Seite 8