Mobile Crossing WayPoint Map Loader Betreibershandbuch Seite 28

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 130
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 27
A calibration report is generated when you perform a calibration to show you what accuracy the process might achieve.
It does this by taking all the calibration waypoints in the file and calculating the Lat/Lon from the Loran as if the Lat/Lon
was not known. Then the distance from the calculated to the real position is figured for each one. The distances for all
the calibration waypoints are averaged and both the average and worst distance is reported. By doing the calibration
with each of the calibration methods above and examining the calibration report, you can find the most accurate method
for you. For mathematical stability, not all of the perceived calibration is applied during the process. Therefore, you
may see some minor improvement by performing the calibration more than once.
3. How to Scale and Manage Maps
Maps are sized to fill the paper to your margin settings. The scale of the map can be set to cover the area you want to
show but remember the screen and paper are different shapes. The simple maps created by the program are Mid Latitude
projections so one degree of longitude is smaller than one degree of Latitude. NOAA maps use Mercator projections that
make the spacing between the Latitude lines vary slightly between the top and bottom of the map. The difference
between these two types of projections is minor over the typical area covered by a fisherman.
The mapping routine in Maps>Create Map uses your default center Latitude to figure the map width rather than using
the actual middle of the map. Therefore, all the maps you make will have the same width to height ratio allowing you to
easily paste them together.
If you have trouble figuring out what Lat/Lon to use to make a map, use the Display>Display On Chart feature to see
where your waypoints are. Pan and zoom around the chart until you are satisfied with the area displayed. Then select
Chart Operations>Make This Chart into A Map to make a map of that area. Keep in mind that the map that will
Seitenansicht 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 129 130

Kommentare zu diesen Handbüchern

Keine Kommentare